ARMORFLO 700 is a two component consisting of epoxy and polyamide resin based topcoat that possess high Physical and chemical resistance. It adheres perfectly to aluminum, galvanized metal and any other metal and also Concrete surfaces. It is a good solution in cases where high performance is of top importance. Also, it is resistant to Mineral oils, sea water and a lot of chemical substances.

 

Download Data Sheet

ARMORFLO 700 is a two component consisting of epoxy and polyamide resin based topcoat that possess high Physical and chemical resistance. It adheres perfectly to aluminum, galvanized metal and any other metal and also Concrete surfaces. It is a good solution in cases where high performance is of top importance. Also, it is resistant to Mineral oils, sea water and a lot of chemical substances.

ADVANTAGES:

  • High chemical and physical resistance
  • Excellent compressive strength
  • Excellent flexural and tensile strength
  • Seamless dust free and easy to clean.
  • Dense corrosion resistant surface

TYPICAL APPLICATIONS:

Armorflo 700 can be applied for floor finish coating on:

  • Industrial and factory floors
  • Water reservoirs
  • Flour silos
  • Petroleum and mineral oil tanks
  • Grain storage bins

APPLICATION INSTRUCTIONS:

Surface preparation;

Surface should be clean and dry and free of impurities and should be coated with primer.

SURFACES WITH PRIMING COAT/INTERMEDIATE COAT: Due attention must be paid to over coating times before applying the top Coat for the surfaces on which a primer and/or an intermediate coat was previously introduced. It is recommended that fully cured Surfaces should be roughened up before applying a top coat.

TOUCH-UP/REPAIR PROCEDURE: Surface to be repaired or touched up will be subjected to cleaning operation to remove Impurities, grease and salt with detergent and high-pressure water, and damaged surfaces will be cleaned by sandblasting Process to meet st-2 and st-3 grade. Cleaned surfaces must be coated with a proper primer. A surface which is dry, clean And/or coated with primer will be deemed proper for paint touch-up/repair.

LINELESS AND/OR NONFERROUS METALS: It is recommended to consult our Technical Support Services for aluminum, galvanized steel, stainless steel, concrete and plastic surfaces.

AMBIENT CONDITIONS: Surface temperature must be +10; +30 °C and relative humidity must be maximum 80% in order to achieve optimal results. Metal surface temperature must be at least 3°C above the dew point of air to avoid condensation on the surface. Good ventilation is essential for drying process in case the application is carried out in a confined space.

There are no reviews yet.

Be the first to review “Armorflo 700”